photo

Vishal Naik


Last seen: 11 días hace |  Con actividad desde 2021

Followers: 0   Following: 0

Estadística

  • Thankful Level 3

Ver insignias

Feeds

Ver por

Pregunta


MATLAB/Simulink/Simscape:Contact force analysis
In Simscape, there are already some blocks available where I can perform contact force analysis by choosing 'Export Entire Geome...

2 meses hace | 1 respuesta | 0

1

respuesta

Pregunta


Simulink- How to control stop time?
How to vary stop time in simulink it self.

4 meses hace | 1 respuesta | 0

1

respuesta

Pregunta


How to control DC motor speed using MATLAB/Simulink+ NI 9403+cDAQ 9171?
I am working on a 2R robot manipulator. I am using MATLAB/Simulink+ NI 9403+CDAQ 9171+ DC motor with encoder+ BTS 7690 motor dri...

6 meses hace | 0 respuestas | 0

0

respuestas

Pregunta


Can anyone suggest how to speed up the simulation?
Here, I have uploaded matlab code and simulink model. The procedure to run the simulink is as follows: Open trail_0 and run it....

6 meses hace | 1 respuesta | 0

1

respuesta

Pregunta


Spatial Contact Force is not sensing normal force, even two bodies are in contact?
Here, I have made contact between the end effector of the 2R robot manipulator and the object, where the ground is inclined. Her...

10 meses hace | 0 respuestas | 0

0

respuestas

Pregunta


Simscape Multibody- How to find location of point of contact between two objects?
I am working on a 2R robot manipulator. I want to find the position of the point of contact made by the 2R robot manipulator wit...

10 meses hace | 2 respuestas | 0

2

respuestas

Pregunta


How to enable geometry block to imported CAD model (STEP) in the Simscape?
I have imported model from solid works into simscape. Now I want to enable geomtry port, but under Geometry parameter of solid ...

alrededor de 1 año hace | 1 respuesta | 0

1

respuesta

Pregunta


MATLAB 2022a and MASC ADAMS View 2018.1 Simulation
I have created control plant from MSC ADAMS view. When I run the simulink model, it automatically close. Can you help me to figu...

alrededor de 1 año hace | 1 respuesta | 0

1

respuesta

Pregunta


Co-Simulation between MSC ADMS View and MATLAB/Simulink---ERROR: PINPUT/0 is not defined in the data set. Command ignored. WARNING: Integrator HMAX could not be determined.
Hi, I am working on a 3R manipulator. I am doing a co-simulation between ADAMS View and Simulink. I have built a model in Adams ...

alrededor de 1 año hace | 1 respuesta | 0

1

respuesta

Pregunta


I want to use atan2 in my equation. When I use atan2 , I get answer NaN. But when I use 'atan' , i didn't get NaN. Why?
clear all clc syms alpha1 alpha1_d alpha1_dd a=3; b=2; th1=atan2(a*sin(alpha1),(b*cos(alpha1))); l1=a*cos(alpha1)*sin(th...

más de 3 años hace | 1 respuesta | 0

1

respuesta