Oliver McEnteggart
Followers: 0 Following: 0
Estadística
CLASIFICACIÓN
11.007
of 300.338
REPUTACIÓN
4
CONTRIBUCIONES
8 Preguntas
1 Respuesta
ACEPTACIÓN DE RESPUESTAS
62.5%
VOTOS RECIBIDOS
4
CLASIFICACIÓN
of 20.922
REPUTACIÓN
N/A
EVALUACIÓN MEDIA
0.00
CONTRIBUCIONES
0 Archivos
DESCARGAS
0
ALL TIME DESCARGAS
0
CLASIFICACIÓN
of 168.149
CONTRIBUCIONES
0 Problemas
0 Soluciones
PUNTUACIÓN
0
NÚMERO DE INSIGNIAS
0
CONTRIBUCIONES
0 Publicaciones
CONTRIBUCIONES
0 Público Canales
EVALUACIÓN MEDIA
CONTRIBUCIONES
0 Temas destacados
MEDIA DE ME GUSTA
Feeds
Pregunta
Running sequential simulations in a simulink model
I have a simulink model with a set of about 10 parameters. I also have a set of about 15 different sets of parameters, I am tryi...
alrededor de 13 años hace | 1 respuesta | 2
1
respuestaOutput first zero of a signal?
Thanks for that help, I have another related question though how would I go about finding the time difference between each succe...
alrededor de 13 años hace | 0
Pregunta
Output first zero of a signal?
Is there anyway to output the first time at which a signal is zero (excluding at t = 0)?
alrededor de 13 años hace | 3 respuestas | 0
3
respuestasPregunta
How to I output the maximum value of a signal to a display?
Is there anyway to output the maximum value of a signal that varies with time in simulink to a display block?
alrededor de 13 años hace | 1 respuesta | 0
1
respuestaPregunta
How to route a signal without routing it through every layer in a simulink model
Is there anyway to route or find the value of a signal that is in a reference model several subsystems below the outer level dir...
alrededor de 13 años hace | 1 respuesta | 0
1
respuestaPregunta
Extracting a response time in simulink
So I have a control system in simulink which I have put into a test harness and I want to find the response time for that system...
alrededor de 13 años hace | 1 respuesta | 0
1
respuestaPregunta
Error: Cannot propogate bus signal from output 1 to input 5
I keep getting this error when I try to run a simulation with a model reference. The signal is created by a subsystem which then...
más de 13 años hace | 1 respuesta | 1
1
respuestaPregunta
Nested buses in base workspace
I'm trying to define a nested bus structure in the base workspace of MatLab. However, I'm not sure how I should actually write t...
más de 13 años hace | 1 respuesta | 1
1
respuestaPregunta
Test harnesses and reference models
Hi, I am making a test harness in simulink to test an actuator model and have ran into a problem. The actuator itself is a re...
más de 13 años hace | 1 respuesta | 0
