La traducción de esta página aún no se ha actualizado a la versión más reciente. Haga clic aquí para ver la última versión en inglés.

Configuración del ajuste de modelos de Simulink

Configure modelos de Simulink^® para el ajuste en la línea de comandos

Para ajustar un modelo de Simulink en la línea de comandos, utilice la interfaz slTuner para configurar el modelo para el ajuste, especifique los bloques que se han de ajustar y especifique los puntos de análisis. La interfaz slTuner almacena una aproximación lineal del modelo de Simulink y otro tipo de información necesaria para ajustar el sistema. Para ver un ejemplo, consulte Create and Configure slTuner Interface to Simulink Model. (El ajuste de modelos de Simulink requiere Simulink Control Design™).

Funciones

expandir todo

Creación de la interfaz slTuner

`slTuner`	Interface for control system tuning of Simulink models
`slTunerOptions`	Set `slTuner` interface options

Modificación de la interfaz slTuner

`addBlock`	Add block to list of tuned blocks for `slTuner` interface
`addOpening`	Add signal to list of openings for `slLinearizer` or `slTuner` interface
`addPoint`	Add signal to list of analysis points for `slLinearizer` or `slTuner` interface
`refresh`	Resynchronize `slLinearizer` or `slTuner` interface with current model state
`removeAllOpenings`	Remove all openings from list of permanent openings in `slLinearizer` or `slTuner` interface
`removeAllPoints`	Remove all points from list of analysis points in `slLinearizer` or `slTuner` interface
`removeBlock`	Remove block from list of tuned blocks in `slTuner` interface
`removeOpening`	Remove opening from list of permanent loop openings in `slLinearizer` or `slTuner` interface
`removePoint`	Remove point from list of analysis points in `slLinearizer` or `slTuner` interface
`setBlockParam`	Set parameterization of tuned block in `slTuner` interface
`setBlockRateConversion`	Set rate conversion settings for tuned block in `slTuner` interface
`setBlockValue`	Set value of tuned block parameterization in `slTuner` interface
`writeBlockValue`	Update block values in Simulink model
`writeLookupTableData`	Update portion of tuned lookup table

Consulta a la interfaz slTuner

`getBlockParam`	Get parameterization of tuned block in `slTuner` interface
`getBlockRateConversion`	Get rate conversion settings for tuned block in `slTuner` interface
`getBlockValue`	Get current value of tuned block parameterization in `slTuner` interface
`getOpenings`	Get list of openings for `slLinearizer` or `slTuner` interface
`getPoints`	Get list of analysis points for `slLinearizer` or `slTuner` interface
`showTunable`	Show value of parameterizations of tunable blocks of `slTuner` interface

Temas

Create and Configure slTuner Interface to Simulink Model
Use slTuner to create an interface to a Simulink model for command-line control system tuning and analysis.
Tune Control Systems in Simulink
At the command line, use systune or looptune to automatically tune control systems modeled in Simulink.
Mark Signals of Interest for Control System Analysis and Design
Analysis points allow you to access to internal signals, perform open-loop analysis, or specify requirements for controller tuning in systems modeled in either MATLAB^® or Simulink.
How Tuned Simulink Blocks Are Parameterized
Both Control System Tuner and the slTuner interface automatically assign predefined parameterizations to certain Simulink blocks.