Generate Code and Deploy Model to Hardware

Step 8 of 8 in Create Custom Device Driver Block for Arduino Library

1. Open the Simulink^® editor.

2. In the Modeling tab, in the Setup section, click Model Settings.

3. In the Configuration Parameters dialog box, select Hardware Implementation and set Hardware board to Arduino^® Mega 2560.

4. On the Hardware tab of the Simulink model, in the Mode section, select Run on board and then click Monitor & Tune to run the model on the Arduino board.

   Observe the RGB color values picked up from the TCS34725 color sensor in their respective displays.

   

Create Custom Device Driver Block for Arduino Library