Problem with connection

49 visualizaciones (últimos 30 días)
Nuno
Nuno el 25 de Jun. de 2011
Hi... I create a model but appear the next error:
"The following two blocks cannot be connected in series because they are modeled as current sources:
Block 1: Ideal Switch1 Block 2: Subsystem/Controlled Current Source
Add a high-value resistance in parallel with one of the two block. You can also specify high-value resistive snubbers if the blocks have a snubber device."
The Ideal Switch1 and the Subsystem/Controlled Current Source was SimPowerSystems but what resistor i use to correct the error?
  1 comentario
Kaustubha Govind
Kaustubha Govind el 27 de Jun. de 2011
I don't have any experience with SimPowerSystems but you could possibly set a large value for the "Snubber resistance Rs" parameter in the Ideal Switch dialog, as the error message suggests.

Iniciar sesión para comentar.

Respuesta aceptada

Nuno
Nuno el 29 de Jun. de 2011
I already put like the image, but appear the same error :( http://img8.imageshack.us/img8/2282/modell.png
The error is: "The following two blocks cannot be connected in series because they are modeled as current sources:
Block 1: Ideal Switch Block 2: Controlled Current Source
Add a high-value resistance in parallel with one of the two block. You can also specify high-value resistive snubbers if the blocks have a snubber device."
  4 comentarios
Nuno
Nuno el 30 de Jun. de 2011
Yes, is resistor only... I put R=10 to R=80000000 but appear the same error :(
Arnaud Miege
Arnaud Miege el 30 de Jun. de 2011
OK, try putting a resistor in parallel with the Controlled Current Source and see if that fixes it.

Iniciar sesión para comentar.

Más respuestas (3)

Arnaud Miege
Arnaud Miege el 28 de Jun. de 2011
Just use a Series RLC Branch in parallel with your ideal switch, but keep everything on the SimPowerSystems side (i.e. the resistor should between ports 1 & 2 of the ideal switch).
HTH,
Arnaud

Nuno
Nuno el 26 de Jun. de 2011
Anyone?

Nuno
Nuno el 28 de Jun. de 2011
I was wrong to explain... I don´t how i put the resistor in parallel, because does not connect as it is: http://img696.imageshack.us/img696/7684/modeln.png

Categorías

Más información sobre Nonlinear Operators en Help Center y File Exchange.

Etiquetas

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by