Simulink display block as stateflow output
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hi, I have following problem, hope some one can help me to solve it. I have Simulink model with Stateflow chart inside. I wish to see all Stateflow outputs using Dispaly block, but it only shows me last output. If I connect Scope I can see all outputs. So question is that I need to do to see all stateflow outputs on the scope.
Thank you.
Regards
1 comentario
Kaustubha Govind
el 31 de Mzo. de 2014
When you say all outputs, do you mean that you have multiple outputs, or that you'd like to see all time-samples for one output signal? If it is the latter, I don't think a Display block would be appropriate.
Respuestas (1)
Chandrasekhar
el 1 de Abr. de 2014
Display block can be used only to see the latest output.but if you want to see how the output varies over a period of time then scope should be used. if you have multiple signals of same data type and wish to watch them in a single scope, then multiplex the signals using a mux block and give it to scope.
0 comentarios
Ver también
Categorías
Más información sobre Simulink Functions en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!