Synchronising Dino-Lite AM2111 Microscope to MATLAB using Image Acquisition Toolbox

4 visualizaciones (últimos 30 días)
I am trying to connect my Dino-Lite AM2111 digital microscope to MATLAB via the Image Acquisition Toolbox. According to the Dino-lite support page under 'Software Usage' > 'Can the Dino-Lite be used with 3rd party software?' it states that it is MATLAB compatible, however when I run the command imaqtool, the only camera that shows up as available is my computers webcam. I have the microscope turned on and I can see that it is picking up images from its own dedicated software. What do I have to do to get it talking to MATLAB?
  3 comentarios
Mihailo Zivkovic
Mihailo Zivkovic el 3 de Feb. de 2015
Did you try closing the DinoCapture software and then run the command imaqtool? I did not have DinoCapture running and imaqtool recognized my Dino-Lite microscope so give that a try.
Andy el 5 de Abr. de 2016
Editada: Andy el 5 de Abr. de 2016
To connect, what I did was install support packages. The General OS one seemed to do the trick

Iniciar sesión para comentar.

Respuestas (1)

Madhura Suresh
Madhura Suresh el 6 de Abr. de 2016
Hi Max,
Looking at the datasheet for the camera, it looks like the camera has directshow drivers. You should be able to use this camera after downloading the "OS Generic Support Package".
Once you install it, try:
imaqhwinfo winvideo
That should list the device.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by