Simulation hangs and crashes when changeing values of capacitors from 10e-6 to 10e-9

3 views (last 30 days)
Hello community,
I have the following problem with Simulink: the simulation generally works without problems. When I change the values of capacitors in my circuit in the range from 10e-6 to 10e-9, the simulation runs up to T= 0.199 from T=0.2 without errors and then Matlab/Simulink and my system hangs. After a short time, Matlab/Simulink crashes. After that, there is no error message or crash report. How can I find out what exactly causes this behavior and how to fix it?
Thank you for your comments :)
MATLAB Version: (R2020a) Update 7
Operating System: Linux 4.19.0-17-amd64 #1 SMP Debian 4.19.194-3 (2021-07-18) x86_64
Java Version: Java 1.8.0_202-b08 with Oracle Corporation Java HotSpot(TM) 64-Bit Server VM mixed mode
MATLAB Version 9.8 (R2020a)
Simulink Version 10.1 (R2020a)
Simscape Version 4.8 (R2020a)
Simscape Electrical Version 7.3 (R2020a)

Answers (1)

Joel Van Sickel
Joel Van Sickel on 20 Sep 2021
Hello Luis,
the fact that it is crashing without a warning is a bug, can you share the model that crashes? On a side note, changing the capacitance to something that small will require a much smaller time step to simulate correctly. To assist with that, you can try changing your simulation relative (and absolute) tolerance to 1e-4 and 1e-5. Make sure to use ode23t or DAESSC as your solver.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by