Validation error, when configuring enable subsystem as autosar component?

9 views (last 30 days)
Hi, when using the enable system's, states when enabling of enable port, if we set as "reset", the following error is popping out.
Error:The trigger or enable port 'untitled/Subsystem/Subsystem/Enabled Subsystem1/Enable' has "States when enabling" set to "reset", which is not supported. You must change this to "held"

Answers (0)


Find more on AUTOSAR Blockset in Help Center and File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by