Borrar filtros
Borrar filtros

Validation error, when configuring enable subsystem as autosar component?

3 visualizaciones (últimos 30 días)
Hi, when using the enable system's, states when enabling of enable port, if we set as "reset", the following error is popping out.
Error:The trigger or enable port 'untitled/Subsystem/Subsystem/Enabled Subsystem1/Enable' has "States when enabling" set to "reset", which is not supported. You must change this to "held"

Respuestas (0)


Más información sobre AUTOSAR Blockset en Help Center y File Exchange.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by