can we control Data Inspector from command line ?
15 visualizaciones (últimos 30 días)
I am using Data logger in 2013 with one of my model.
After configuring the signals to log , I run a script which simulates my model several times ( I give simulation start and stop commands in the script)
Once do that, I can see too many runs in the data inspector.
I can delete the these runs using command line simulink.sdi.deleterun but is it possible to prevent the run from being captured by Data Inspector ? rather than deleting it later ?
Frank Zhou el 15 de Mayo de 2019
There is a related question with an answer on this thread:
Hope this helps!