Error with the PV array simulation

5 visualizaciones (últimos 30 días)
Jung Sunghun
Jung Sunghun el 16 de Nov. de 2021
Comentada: Jung Sunghun el 3 de Dic. de 2021
I am currently trying to simulate a single PV cell which I bought from the following link (
With the PV cell information given in the above link, I built the attached Simulink model to simulate a PV cell's behavior.
However, outputs of current and voltage sensor are a bit strange. I am expecting the voltage range around 0.682 V and current range around 6.24 A, but the sensor ouputs are too huge as shown in the attached pics.
Is there anyone who can help to solve this problem or give me any related information which I can refer?
Thank you very much.
  1 comentario
Jung Sunghun
Jung Sunghun el 16 de Nov. de 2021
The following video might help the above problem.

Iniciar sesión para comentar.

Respuesta aceptada

Joel Van Sickel
Joel Van Sickel el 29 de Nov. de 2021
Hello Jung,
you are applying a constantly increasing voltage to the output of the solar cell, so you couldn't get a fixed voltage. You can replace the controlled voltage source with the appropriately sized resistor to see if you get the expected voltage and current. For your numbers I'd guess a resistance of 0.1 would be close to what you are looking for. I would also use scopes instead of displays so you can see the time varying behavior of the model.
  1 comentario
Jung Sunghun
Jung Sunghun el 3 de Dic. de 2021
Thank you very much for your suggestion. I will try the above method.

Iniciar sesión para comentar.

Más respuestas (0)


Más información sobre Electrical Block Libraries en Help Center y File Exchange.


Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by