Modelling a spinning disk attached to a rod in simscape multibody
11 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Jake Barlow
el 28 de Dic. de 2021
Respondida: Steve Miller
el 10 de En. de 2022
I am trying to model gyroscopic behaviour with a disk attached to the end of a rod. The rod is fixed at the top by a spherical joint. The system is supposed to behave like a pendulum, but also shift in trajectory due to the rotating disk, i.e. not just back and forth motion in a single vertical plane. I have defined spatial contact forces to model the contact between the base of the rod and top of the spinning disk. However, after defining the spatial contact forces between the disk and rod, the system only rotates about its vertical axis and there is no pendulum-like behaviour.
Could you please help me include translational behaviour into the system according to the rotation of the disk (and also stop the rod rotating along its vertical axis so that only the disk rotates along its vertical axis)?
I have added the draft model and diagram of the system below. I am trying to define a multibody system of which one element is a gyro or spinning disk, while the other is modelled as a rod which does not rotate along its vertical axis. Here is what I am trying to model https://www.youtube.com/watch?v=pKGgICawAKc, but with a spinning disk instead of a sphere.
Thank you for your help. Much appreciated.
0 comentarios
Respuesta aceptada
Steve Miller
el 10 de En. de 2022
A model that is quite close to what you describe has been attached to this post:
--Steve
0 comentarios
Más respuestas (0)
Ver también
Categorías
Más información sobre Assembly en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!