- The output is great or equal to the period of your repeating sequence, or
- Whatever condition you desire
Reset Repeating Sequence Block
12 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Jacob Rhodes
el 22 de Jun. de 2022
Comentada: Jacob Rhodes
el 29 de Jun. de 2022
I am trying to implement a Repeating Sequence block that can be reset to its initial state based on a condition. I've attempted to use a Resettable Subsystem as this works with a Sample Based Pulse Generator, but it does not provide the same behavior for the Repeating Sequence. Anyone have any possible solutions? I need to be able to create a signal that can repeatedly ramp up and ramp down, but only start and be reset when a given condition is met, which is why I gravitated towards the Repeating Sequence block.
0 comentarios
Respuesta aceptada
Fangjun Jiang
el 22 de Jun. de 2022
Editada: Fangjun Jiang
el 22 de Jun. de 2022
If you look inside the mask of the "Repeating Sequence" block, you will see it is built on top of the 1-D lookup table.
To achieve what you want, you can use an Integrator block with external reset. The input is 1 so the output is basically the simulation time t. The output is reset by
Feed this output to a 1-D lookup table, where you specify your repeating sequence data.
3 comentarios
Fangjun Jiang
el 29 de Jun. de 2022
Show or log data points of the curve to debug the issue. My suspicion is that Simulink adjusts the simulation step size due to the stiffness at the tip of the curve.
If no other constraints, set the solver to be discrete with fixed step size as 0.001. The problem should disappear.
Más respuestas (0)
Ver también
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!