Simulink Transmission Shift Map

6 visualizaciones (últimos 30 días)
MATLAB_Soldier
MATLAB_Soldier el 28 de Sept. de 2022
Comentada: Fangjun Jiang el 11 de Nov. de 2022
Hello,
I am trying to create a system that would decide if the vehicle needs to shift up or down based on the vehicle speed gradient, the current speed and the following shift map:
I have come up with a simple method that would use a lookup table to decide on the appropriate gear selection. However, I am not sure if this is the best way to go about it. I know that it is possible to do the whole process using StateFlow but unfortunately, it is not available for me. Therefore, I need figure out how to make it work without stateflow.
Is it possible to do it with a lookup table or do you think there is a better way to do it?

Respuestas (1)

Fangjun Jiang
Fangjun Jiang el 29 de Sept. de 2022
It is possible and you are almost there.
You have the logic to check whether the speed is increasing (for up shipt) or else (for down shift). You only need a 1-D lookup table block with one input, which is the vehicle speed. The vehicle speed threshold would be the index. The gear number would be the output.
You will need two 1-D lookup tables (one for up shift and one for down shift). Use a Switch block to switch the output. Or Use a Merge block (which is more efficient but requires Enabled sub-system).
  2 comentarios
Beau Tucker
Beau Tucker el 11 de Nov. de 2022
Could you explain the values in the lookup table? Specififcally how to obtain those values? Thank you.
Fangjun Jiang
Fangjun Jiang el 11 de Nov. de 2022
The values for the lookup table are provided in the Original Poster's question.

Iniciar sesión para comentar.

Categorías

Más información sobre Programmatic Model Editing en Help Center y File Exchange.

Productos


Versión

R2021b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by