how do i make this pv model work

13 visualizaciones (últimos 30 días)
Olufemi Olayiwola
Olufemi Olayiwola el 12 de Mzo. de 2015
Comentada: Joe Jones el 21 de Sept. de 2023
I am trying to simulate a pv cell but the current controlled source block is giving the error "The 'CCS' block cannot be left open-circuit because it is modeled as a current source. You should try to resolve the open-circuit topology or delete this block from your model." How do I resolve this and make the circuit work.
  1 comentario
Joe Jones
Joe Jones el 21 de Sept. de 2023
I have the same error. Can you tell me the solution to this error?Thank you very much.

Iniciar sesión para comentar.

Respuestas (3)

A Jenkins
A Jenkins el 12 de Mzo. de 2015
Close the circuit. You say you have a source of current, so where does that current go? Perhaps a resistor as a load?

anbumani p
anbumani p el 22 de En. de 2023
The 'Controlled Current Source' block cannot be left open-circuit because it is modeled as a current source. You should try to resolve the open-circuit topology or delete this block from your model.

Xing
Xing el 24 de Jul. de 2023
I have the same question. Even I give a constant value by Simulink block and connect the controlled current source block and also the two electrical ports are already connected. I got the same error.

Categorías

Más información sobre Schedule Model Components en Help Center y File Exchange.

Etiquetas

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by