Servo motors connected to the aux channel of Pixhawk jitter
17 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Daehee Lim
el 25 de Oct. de 2022
Respondida: Manoj Velmurugan
el 31 de Oct. de 2022
I uploaded the auto generated code to pixhawk and I connected two servo motors to the aux out and main out respectively.
The servo motor connected to the main out moves with the increasing throttle position, however, the servo motor connected to the aux out jitters whether the throttle increases or not.
What do I need to do?
1 comentario
Manoj Velmurugan
el 27 de Oct. de 2022
I checked your model's configuration which appears fine. 50Hz PWM frequency for servos should be fine.
You could try using a logic analyzer on servo channel to observe the ON time. In case that fluctuates, problem is on the input side.
Else it could be a power supply issue.
Respuesta aceptada
Manoj Velmurugan
el 31 de Oct. de 2022
I checked your model's configuration which appears fine. 50Hz PWM frequency for servos should be fine.
To find the exact cause, you could try using a logic analyzer on servo channel to observe the on-time of PWM signal going to the servo. In case it fluctuates, problem is on the generated PWM signal.
Else it could be a power supply issue.
0 comentarios
Más respuestas (0)
Ver también
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!