Borrar filtros
Borrar filtros

How to get continuous time display for oscilloscope?

7 visualizaciones (últimos 30 días)
Will Banks
Will Banks el 11 de Feb. de 2023
Editada: Will Banks el 17 de Feb. de 2023
I searched already and couldn't find an answer.
I have a circuit that generates a ramp wave. The circuit works on other simulation software, and it works in real life as I've built it before.
When I attach a probe to the output, I get a DC signal. I am assuming that the scope takes a snapshot for something that it thinks is DC, and a time axis if it detects a dedicated AC signal.
Does anyone see anything wrong with the parameters I have specified? cap=2.2nF, R=1k.
The voltage follower simply copies the signal to ensure there is no short to ground.
Thanks fellas, ya'll are baller.
  2 comentarios
Sabin el 14 de Feb. de 2023
Could you attach the model rather than the print screen? Will be easier to investigate as we don't have all the information.
Will Banks
Will Banks el 14 de Feb. de 2023
yes, here you go. thank you

Iniciar sesión para comentar.

Respuestas (1)

Joel Van Sickel
Joel Van Sickel el 16 de Feb. de 2023
Looking at this circuit, shouldn't it require an inverting trigger to work correctly?
  5 comentarios
Joel Van Sickel
Joel Van Sickel el 17 de Feb. de 2023
Editada: Joel Van Sickel el 17 de Feb. de 2023
I'd be interested to see why the not gate doesn't work, but let's assume that won't work based on what you've seen, so you could feed the original signal into a not gate, and then feed the not gate results into the schmitt trigger, essentially creating your own inverting schmitt trigger.
I tried parameterizing the schmitt trigger as if it were inverting, and it wouldn't let me, which would have been a nice alternative.
You could also try and find a spice model of the trigger you used and use the subcircut2ssc command to import that into simscape.
Will Banks
Will Banks el 17 de Feb. de 2023
Editada: Will Banks el 17 de Feb. de 2023
boo yah! some real progress here. this isnt the result i want, but i may be able to change the parameters a bit to get what i want.

Iniciar sesión para comentar.


Más información sobre Get Started with Simscape Electrical en Help Center y File Exchange.


Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by