I am getting an error 'Output Port 1' of 'Wind_Turbine/Scopes/Blade Load Scopes i not connected." when i run the model below but I'm not sure where to connect the in/output
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
Karam Karas
el 7 de Abr. de 2023
Respondida: Dimitri MANKOV
el 11 de Abr. de 2023
I am getting an error 'Output Port 1' of 'Wind_Turbine/Scopes/Blade Load Scopes i not connected." when i run the model below but I'm not sure where to connect the in/output ?
0 comentarios
Respuesta aceptada
Dimitri MANKOV
el 11 de Abr. de 2023
Hi Karam,
It looks like these output ports are not used anywhere in your model, so you can simply delete them to get rid of the warning message.
I hope this is helpful!
Dimitri
0 comentarios
Más respuestas (0)
Ver también
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!