PIL testing with Arduino - codertarget.arduinobase problem
12 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hello
I'm trying to proceed the the PIL testing using ESP32WROOM board. Model and board is configured, are there is no problem to built and deploy generated code to HW. The problem occurs while the generating the PIL submodel. The following error occurs:
Unable to resolve the name 'codertarget.arduinobase.board.ESP32WROOMArduinoCompatibleBoard'.
Error:Cannot perform PIL simulation for "ExampleChart".
Configuration parameters for this model do not support these connectivity configurations: Arduino Board, Texas Instruments Code Composer Studio (IDE), Texas Instruments Code Composer Studio (TCP/IP), Texas Instruments Code Composer Studio (Serial)
Is my model configuration invalid or there is problem with board drivers? I tried to make PIL testing on the simplest model available, but the error is ambiguous and I'm not able to resolve this.
Thanks for help.
0 comentarios
Respuestas (1)
Sarthak
el 21 de Abr. de 2023
Hi Grzegorz,
After looking at your error messages, as per my understanding the issue may be with the board driver not properly installed or configured.
Make sure your driver is properly installed and configured and that your model settings are compatible with the PIL testing.
Attaching a documentation link with step-by-step procedure to set-up and configure ESP32 Hardware
3 comentarios
Sebastian Gieray
el 27 de Jun. de 2023
I have the same problem as you. Have you solved the problem in the meantime and can you help me further?
Best Regards,
Sebastian
Ver también
Categorías
Más información sobre Device Driver Blocks en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!