How to solve the problem that, does the following resistor block value match the plotted requirement resistor: V?
18 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
this's last tast in onramp cours Power electronic. after connecting the components like requiet in the course this message of error are coming. The resistor block value match the plotted requirement resistor: V.
0 comentarios
Respuestas (1)
Pranjal Saxena
el 28 de Jul. de 2023
Hi Mukendi,
I understand that you are getting error as you have not added the solver configuration block to your physical network.
Each physical network represented by a connected Simscape block diagram requires solver settings information for simulation. The Solver Configuration block specifies the solver parameters that your model needs before you can begin simulation.
Every physical network needs a Solver Configuration block. If you have several physical networks and some Simulink Blocks in between you will have to use one Solver Configuration for each physical network.
Refer to following documentation for further understanding on Simscape and Solver configuration:
I hope this helps.
Warm Regards,
Pranjal.
1 comentario
Ver también
Categorías
Más información sobre Troubleshooting en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!