PID Tuner App not open from Simulink PID Controller block?
10 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hello Everyone,
When I click on the Tune button, it starts linearization but PID tuner app does not open. I followed the suggested fixes in the following post but it was not fixing the issue:
However, when I open PID tuner outside of the simulink, it will open properly. Moreover, when no signal is connected to the PID controller, PID tuner app will show up. Is there any fix for this issue? Thanks
1 comentario
Jaynik
el 25 de Sept. de 2023
Hi Ali,
I see that you are trying to open the PID Tuner app from Simulink but are unable to do so. To reproduce the issue on my end, can you help me with the steps you have taken in modelling your simulation. Specifically, it would be helpful if you could share the model used and information about output on the command window or if you have set some specific parameters/settings.
Respuestas (1)
Neelanshu
el 5 de En. de 2024
Hello Ali,
I understand from your query that you need assistance with opening “PID Tuner” app when the “Tune” button is clicked within your model.
I assume that your model might have a discrete-time block. When the “PID controller” block is set to continuous but receives a discrete input, it will cause the “PID controller” block to be also discrete and it will not linearize properly. Since the model does not fully linearize, the app did not come up.
Kindly check the signals going into the “PID controller” block and make sure that they match with the settings within “PID controller”.
Hope this helps,
Regards,
Neelanshu
0 comentarios
Ver también
Categorías
Más información sobre PID Controller Tuning en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!