How can I receive a particular device signals using USRP?
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Muhammad Awais Khan Bangash
el 19 de Oct. de 2023
Respondida: Walter Roberson
el 19 de Oct. de 2023
I am receiving signal from USRP using MATLAB, but I only want to receive the signal of a particular device ie: Micaz how can I do that when multiple devices in the room are operating at the same frequency?
2 comentarios
Walter Roberson
el 19 de Oct. de 2023
Would this be inside Simulink, or using MATLAB-level functions?
Muhammad Awais Khan Bangash
el 19 de Oct. de 2023
Editada: Muhammad Awais Khan Bangash
el 19 de Oct. de 2023
Respuestas (1)
Walter Roberson
el 19 de Oct. de 2023
If you have the cooperation of the device you want to talk to, then see techniques such as those described at https://www.mathworks.com/help/supportpkg/usrpradio/ug/packetized-modem-with-data-link-layer.html . That permits you to create data links -- so each packet of data to be sent out would be tagged with it source and destination link address, and data that is not part of the flow should (ideally) be dropped by the link. Or at the very least you would be able to tell where the packet is from and drop the packet.
0 comentarios
Ver también
Categorías
Más información sobre Communications Toolbox en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!