- Power cycle the ZCU111 board to reset its state. This can clear any temporary issues that can affect the hardware setup.
- Run the hardware setup process again within MATLAB.
SoC Builder fails hardware setup and crash
14 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Has anyone experience SoC Blockset failing to setup hardware shown below? If so, how did you resolve it? My design is targeting ZCU111 Evaluation Kit at the top module and processor levels
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1578336/image.png)
0 comentarios
Respuestas (1)
SANKALP DEV
el 2 de En. de 2024
Hello John,
I understand that you are facing error while setting up hardware using the SoC blockset.
To address this issue, you can consider following workarounds:
Please follow ‘Hardware Setup’ section as mentioned in documentation below:
After the hardware setup, you can try SoC builder again.
Hope this helps.
Regards,
Sankalp dev
Ver también
Categorías
Más información sobre System on Chip (SoC) en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!