Heat transfer area in single and two phase pipe
5 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Delika Weragoda
el 13 de Mzo. de 2024
Editada: Delika Weragoda
el 16 de Abr. de 2024
Hi,
Is there a method to change the heat transfer area in a pipe (TL) and pipe (2p)? The existing blocks consider the entire area (i.e. perimeter x length of the pipe), however if we only want to consider a section of this to be the heat transfer area (say for a pipe with rectangular cross section, we only consider one of the faces to be the area of heat tranfer) how would we get that done. Do we need to build a custom block for this, or is there another block?
Thanks
0 comentarios
Respuesta aceptada
SOUMNATH PAUL
el 8 de Abr. de 2024
Hi,
MATLAB/Simulink does not offer a standard block specifically designed to adjust the heat transfer area in pipes to only a section of the surface.
You will likely need to create a custom block to specify a different effective heat transfer area.
Here is how you can do it, refer to the following link:
For a pipe with regular cross-sectional area where only one face is used for heat transfer, we can calculate the effective area as , (A_{eff} = Width/ times Length)
Kindly adjust the input parameters in existing blocks to use the effective area instead of full pipe surface area.
Thanks,
Soumnath
0 comentarios
Más respuestas (0)
Ver también
Categorías
Más información sobre Elements en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!