Could not connect to Zynq hardware board using IP address 192.168.1.101.

11 visualizaciones (últimos 30 días)
koushik
koushik el 9 de Abr. de 2024
Comentada: Manikanta Aditya el 9 de Abr. de 2024
Could not connect to Zynq hardware board using IP address 192.168.1.101.
Check that your device is connected to a LAN or direct network connection accessible from the MATLAB development computer
  2 comentarios
Manikanta Aditya
Manikanta Aditya el 9 de Abr. de 2024
As mentioned, try checking your connection as well, and ensure that the USB cable is plugged into the ‘USB-to-UART’ port of the hardware and the power switch is turned on. If this error persists, switch off the hardware, wait for 10 seconds, switch on the hardware and then repeat this step.

Iniciar sesión para comentar.

Iniciar sesión para responder a esta pregunta.

Respuestas (0)

Categorías

Más información sobre Targeting FPGA & SoC Hardware en Help Center y File Exchange.

Etiquetas

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by