Connect USRP-2974 using Wireless Testbench
13 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hi, MATLAB Community,
I wonder if the NI USRP-2974 is compatatible with Wireless Testbench Toolbox.
Although NI says that USRP-2974 is X310 with an on-board computer, I failed to run WT examples. I noticed that Wireless Testbench supports NI USRP-295x (X310 with specific daughterboards, I tested with another USRP-2952) but it seems 2974 is not supported.
An error message says Unable to find a compatible radio, 'USRP X310'
Thanks in advance
0 comentarios
Respuestas (1)
Martin Enderwitz
el 13 de Ag. de 2024
Editada: Martin Enderwitz
el 14 de Ag. de 2024
While we have not been able to test and verify that Wireless Testbench works with the USRP-2974, it should theoretically be possible, since as you note this is effectively an X310.
It looks like this requires connecting your host PC to SFP1 on the USRP-2974 for access to the X310 FPGA, rather than the on-board computer (which is not compatible with Wireless Testbench): https://knowledge.ni.com/KnowledgeArticleDetails?id=kA03q000001DsV3CAK&l=en-GB
Since you're connecting to Port 0 of the X310, the IP address will be different depending on whether the HG or XG FPGA image is loaded by default. This will also determine the type of host network interface you need (1 Gigabit or 10 Gigabit). It is my understanding that HG is the default image, so will be configured for a 1 Gigabit interface at 192.168.10.2.
Again, we can't guarantee this will work as we have not tested this ourselves but you could connect the NI-2974 (SFP1) to a 1 Gigabit Ethernet interface on your host PC and it should hopefully be usable with Wireless Testbench at the designated IP address.
Ver también
Categorías
Más información sobre Communications Toolbox en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!