Edit Code Initialization under Mask editor

I am creating the mask for my simulink block and I need to add the Initiallization code to it. Unfortumatelly I can't edit (add) code within the mask editor; it's grayed and not editable, disabled.

How can I access this, and add the initialization code to it?

Thank you.

Answer 1

[Meet]

Hi Jack,

I faced a similar problem and found that there are two ways to save callbacks: either within the mask or in a separate callback file. It is possible that your Mask Editor is set to "Callback file" under "Switch Callback Mode." If you change this setting to "Mask," you should be able to edit the initialization code directly in the editor. I have attached an image to guide you through this process.

I hope this helps resolve the issue!

[Jack Daniels]

Hello,

I did as you suggested. The code editor is not grayed but still disabled, not accessible and not possible to edit.

then it's neeed to click "+" to start the code edit to be accesibale/editable :)

Thanks for suggestion and point me to the right direction!