Toolbox that requires a ID of ModelAdvisor

Could you please share the ToolBox information required to use the following IDs in the Model Advisor?

1. db_0144
2. jc_0803
3. jc_0805
4. jc_0711
5. jc_0657
6. jc_0491
7. na_0025

Answer 1

[Haelee]

Hi, Dogyun.

Unfortunately, the checkers you mentioned are not supported on MathWorks products for two reasons. In the Model Advisor Checks for MAB Modeling Guidelines, each check shows either a "No check" or "Not checkable" status, with the following meanings:

• No check: The guideline could be checked using a Model Advisor check, but the check does not currently exist.
• Not checkable: It is not possible to verify compliance to this guideline using a Model Advisor check.

The items marked as "No check" (like jc_0805, na_0025) are not supported right now. They might be supported in the future, but they are not available in the latest version.

The items marked as "Not checkable" (like db_0144, jc_0491, jc_0657, jc_0711, jc_0803) are things that Model Advisor cannot check automatically. For example, db_0144 says that Subsystems should be grouped by function, not just for appearance. To check this, we need to know the context of the design, which cannot be checked automatically by code.

For both "No check" and "Not checkable" items, manual review is required. If you click on each check in the document, examples are provided that describe how to perform the manual review.

If you have further inquiry, please note that can submit your question through MathWorks Technical Support.

Thank you.