Command Window doesn't respond and prompt signs are missing (R2015b)
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hi there,
In my Matlab version R2015b (64bit), running on a Computer with Windows 10, the command window doesn't respond to anything I type. This means, that it shows the words I entered, but doesn't give an answer (resp. shows the result), nor does it show the prompt signs. However, the instructions I typed in the command window, appear in the history... The screenshot in the appendix shows my issue.
Next to the version R2015b, I have the R2014a installed, which works perfectly. Do you think it could be a problem running two different versions on a single computer?
Thanks a lot for your support!
1 comentario
Respuestas (1)
d p
el 15 de Jul. de 2016
Editada: d p
el 15 de Jul. de 2016
Same here, with an attached pic. r2016, restarting will probably solve the problem.
2 comentarios
Image Analyst
el 16 de Jul. de 2016
It still thinks you're entering code, like you're adding lines to a for loop or something. You probably did something like that. I see some ends up there - maybe you need another one to end this block of code. Or else just type control-c to bail out of everything.
Ver también
Categorías
Más información sobre Introduction to Installation and Licensing en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!