Co-Simulation with NXMotion and Matlab/Simulink
22 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Yazdan Kordestany
el 25 de Mayo de 2016
Respondida: Yukthi S
el 16 de Jul. de 2024 a las 3:53
I created three different input data in my Simulink model to use in the NXMotion Plant Block as Plant Input. However, NXMotion Plant Block uses Mux block for input data to combine them to a single signal. Is there any way to have my inputs as separate signals?
Thanks,
0 comentarios
Respuestas (1)
Yukthi S
el 16 de Jul. de 2024 a las 3:53
Hi Yazdan,
To propagate separate signals as inputs to the NXMotion Plant block, a Bus Creator block available in Simulink can be used and I assume that the latest version of MATLAB is being used, as no specific version information was provided.
1. Firstly, configure the Bus creator block to have 3 input ports and connect the input signals to it.
2. Then connect the Bus creator block output to the input of NXMotion Plant block, assuming NXMotion Plant block is configured to accept bus signals as input.
The following documentation can be referred to know more about Bus creator block:
Hope you will find this helpful.
0 comentarios
Ver también
Categorías
Más información sobre Development Computer Setup en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!