Borrar filtros
Borrar filtros

When i am trying to compile this model(attached below),error in port widths and dimensions shows up. Help me try to get rid of this error and run the model successfully.

4 visualizaciones (últimos 30 días)

Respuesta aceptada

Hari Desanur
Hari Desanur el 30 de Dic. de 2016
Click on the 'Mux blocks used to create bus signals' link in the error message and then set the setting in Configuration Parameters to 'error'.
Also view the signal dimensions by clicking on 'Display' -> 'Signals & Ports' -> 'Signal Dimensions'.
I looks like the root cause of the issues in your model is that the 'PWM Generator' input to the 'Boost Converter' subsystem has a dimension of 12 which is later passed to the 'Mosfet' block in the 'Boost Converter' subsystem.
The basic logic in your model might have some issues.

Más respuestas (0)

Categorías

Más información sobre Modeling en Help Center y File Exchange.

Etiquetas

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by