How to connect a Harvard Apparatus PHD Ultra Pump to MATLAB using USB?
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
I am trying to use MATLAB to send commands to a Harvard Apparatus PHD Ultra pump using USB. I was told by the manufacturer that the best way to do this is to use the VISA protocol. I have the NI-VISA support package installed.
Here is the code I have been trying to use to connect to my device:
pump1 = visa('ni','USB::1FE9::1103::D-402110::INSTR');
fopen(pump1);
When I run this code, I receive the error
Invalid RSRCNAME specified. Type 'instrhelp visa' for more information.
I am basing the resource name off of the serial number on my device and information found in the 'properties' section of the USB device in windows.
1 comentario
Jeremy Scholze
el 29 de En. de 2019
Hi,
Did this ever work? I'm trying to program a PHD ULTRA with MATLAB but I don't even know how to set it up. Is there a link or any directions someone can give me. I can't find anything on Harvard Apparatus's website.
Respuestas (1)
Sid Jhaveri
el 9 de Jun. de 2017
As the error suggests the resource name given is invalid. I would suggest to try the following steps:
1) Make sure your device is detected in NI-Max.
2) Once it is detected, check the details of the device in NI-Max, there will be a generated resource name for your device. Use that as the resource name.
0 comentarios
Ver también
Categorías
Más información sobre Instrument Control Toolbox Supported Hardware en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!