Why does running Simulink in rapid acceleration mode cause a compiler error indicating that the line is too long?
11 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
MathWorks Support Team
el 20 de Jun. de 2017
Editada: MathWorks Support Team
el 2 de Sept. de 2021
I have a model that I would like to run in rapid acceleration mode. However, when I attempt to run it, I get a compiler error, culminating in the following lines:
model_name.c:134 compiler limit: line too long (more than 20197 chars)
gmake: *** [model_name.obj] Error 1
I tried moving the files to a shorter directory, but that had no effect. What is causing this issue?
Respuesta aceptada
MathWorks Support Team
el 17 de Ag. de 2021
Editada: MathWorks Support Team
el 2 de Sept. de 2021
This error may occur if the you do not have any installed/configured compilers (as may be verified by the output of the command "mex -setup"), in which case MATLAB defaults to lcc.
The issue can be corrected by installing a supported compiler. Supported compilers are listed in the documentation at the following link:
0 comentarios
Más respuestas (0)
Ver también
Categorías
Más información sobre MATLAB Support for MinGW-w64 C/C++ Compiler en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!