How to solve the 'StopFcn' error when the cause is "Vectors must be the same length."
38 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
I have got a simulation file for a grid-tie inverter, which I am going to leave its image below. When I run the simulation, I receive the following error:
Error evaluating 'StopFcn' callback of block_diagram 'DC2ACGRID2'.
Caused by:
Vectors must be the same length.
I cannot figure out what vectors are causing this trouble. Any help is very much appreciated.
16 comentarios
Walter Roberson
el 13 de Mayo de 2021
set_param('YourModelNameGoesHere', 'StopFcn', '')
then save your model.
Lazar Dulovic
el 30 de Jun. de 2022
Respuestas (1)
Scout Patel
el 31 de Mzo. de 2021
- Go to the "MODELING" tab on the simulink window.
- In the Center click on "Model Settings".
- Under Data Import/Export UNCHECK the box next to: "Single Simulation output:"
2 comentarios
Ver también
Categorías
Más información sobre Programmatic Model Editing en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!