I want to cycle the signal simulink according to my application i can't use any repeat blocks.How can i do it ?
6 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Harini pushparaj
el 30 de Oct. de 2017
Comentada: Harini pushparaj
el 30 de Oct. de 2017
Hi...I have a specific length of signal.I don't know the length of the signal .I should repeat the signal.If youu see in the file I have already created a single cycle but sending the speed and time data in the look up table and got the single cycle .I want to repeat the cycle.
0 comentarios
Respuesta aceptada
Fangjun Jiang
el 30 de Oct. de 2017
Editada: Fangjun Jiang
el 30 de Oct. de 2017
It is somewhat difficult to repeat a user defined signal input in Simulink. In your case though, I can think of a solution.
Since you have the single cycle data in the 1-D lookup table, your must know the time duration of your single cycle signal. Let's say the data is from time 0 to time 8.4 seconds, you can add an "Interpreted MATLAB Function" block between the Clock and the lookup table block. The function you need to specify is mod(u,8.4), you will then get an endless repeat of your single cycle signal.
6 comentarios
Más respuestas (0)
Ver también
Categorías
Más información sobre Sources en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!