External mode run but not update data in F28379D
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
diego alexis aragon sotelo
el 26 de Dic. de 2017
Respondida: Venkatesh Chilapur
el 3 de En. de 2018
Hi. i have a F28379D running whit simulink C2000, but when i interrupt system or activate a subsystem whit a trigger, the external mode run, but not update the data, and all displays shows 0.0
i only have this problem whit F28379D, bacause i try the same code in a F28335 and work very well in external mode.
i have this configuration: clock configuration
CSI_A configuration:
i only have this problem when use trigger or try use interrupt system.
thank.
0 comentarios
Respuestas (1)
Venkatesh Chilapur
el 3 de En. de 2018
Hi,
Please refer this post.
https://www.mathworks.com/matlabcentral/answers/327190-how-can-i-establish-can-communication-using-simulink-and-ti-f28379d-processor
Ensure your CAN message are coming properly.
Regards,
Venkatesh C
0 comentarios
Ver también
Categorías
Más información sobre Instrument Control Toolbox Supported Hardware en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!