Error while loading interface model of QPSK HW/SW AD9361 example interface model

In the factory configuration, toolchain cannot be set to "Xilinx Software Development Kit (SDK)" when 'Hardware board' is set to "Xilinx Zynq Based Radio Board Target". In the model configuration properties, above settings are present by default and I have not changed any of the configuration parameters. This error keeps occurring frequently. But on re-run, sometimes the model runs on the PICOZED hardware without any errors. How to resolve this issue?

Answer 1

[Emmanouil Tzorakoleftherakis]

Hi Vinay,

I am assuming you are referring to this example. Try following the steps under the "Setup" section in the link, i.e., reinstall the two support packages and run the configuration steps again to make sure everything is set up properly. If this does not resolve the issue, can you reply with the exact error that you are getting?

[Vinay GB]

Hi Emmanouil , I had re-run the setup many times. But this error keeps coming up often. Attached is the screenshot of error message.