[Simscape Thermal Liquid] Simscape sets wrong maximum valid liquid temperature

Hello,

I have built a thermal liquid model in Simulink/Simscape. It is a network of 62 pipes (TL) between two reservoirs (TL) at the inlet and the outlet of the system.

In the Thermal Liquid Settings I have set a maximum valid temperature of 553.15 Kelvin. All pipe initial temperatures are equal to the inlet temperature.

But if I set an inlet temperature that is greater than 373.15 Kelvin, Simulink says while compiling:

"Error compiling Simscape network for model Thermal_Modell_simscape.

Caused by:
['Thermal_Modell_simscape/OIL.Segment04']: Initial liquid temperature must be less than or equal to Maximum valid temperature.
In foundation.thermal_liquid.elements.pipe_resistive_compressibility (line 38)"

So the initial liquid temperature in the 4th pipe shall be higher than the maximum valid temperature.

I have checked the values and the units. The Thermal Liquid Settings Block is connected with the network between the Inlet and the 1st pipe. The density and all other by-temperature-defined parameters at the Maximum Valid Temperature are correct and defined in the thermal liquid settings.

So I don't understand this error. Can anybody help me?