PZMAP IS NOT ACCURATE
9 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Dear all
I found a bug of matlab. when I use the matlab function "pzmap" to draw the poles and zeros, these poles should be located on the unit circle, however, in the matlab, they are located outside of the unit circle. Please have a look at the code below: the poles should be:p1=exp(-jwg*Ts), p2=exp(jwg*Ts). However, when we use "pzmap" to draw it, it is outside of the unit circle. Does anyone know how to solve it?
%%the matlab function is as follows: %% Ts=1e-4; wg=2*pi*50; z=tf('z'); Gc=(z^2-1)/(z^2-2*z*cos(wg*Ts)+1); pzmap(Gc); %%
0 comentarios
Respuestas (2)
Birdman
el 5 de Abr. de 2018
Do not be bothered by that. You know that the magnitude of the pole should give you 1:
0.9995^2+0.0314^2=1
The reason it stands outside has something to do with your sampling time. If you check the Bode plot of the system, you will see that even sampling with 10kHz is not enough since the magnitude at that frequency is still high comparing to low frequencies. Therefore choose your sampling time as high as possible. The poles will stand closer to the unit circle, but will not be exactly on the unit circle. For instance increase the sampling time to 1e-8 and observe the Bode plot again.
bode(Gc)
Hope this helps.
8 comentarios
Birdman
el 5 de Abr. de 2018
But conversion fron continuous to discrete always contains this kind of tradeoffs. Therefore my suggestion is to make analysis via Bode plots.
Ver también
Categorías
Más información sobre Stability Analysis en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!