# Control of Stepper Motor with Simulink

8 visualizaciones (últimos 30 días)
Nicky Man el 6 de Abr. de 2018
Respondida: Michael Goebel el 24 de Jun. de 2020
Hi there!
I have a program that tells the step sequence for a step motor to take. So far, I have been able to make the stepper motor turn clockwise and counter-clockwise. I did this using a repeating sequence stair, where the output is [0,1,2,3], and the sample rate is .01 seconds
Now I want that if I push a button (eg. arduino push button), then the repeating sequence stair logic will operate for 5 seconds. However, the repeating sequence stair logic is a source with no input.
Therefore, my question now is, how do I integrate an if statement so that when the push button is pressed, then the repeating sequence stair logic will initiate for five seconds?
Hardware used:
Arduino Uno
5 Volt DC 28BYJ-48 step motor
Motor Driver Board ULN2003
-----
Thanks, Nick
##### 2 comentariosMostrar NingunoOcultar Ninguno
Cosimo Mercuro el 5 de Mayo de 2018
Hi Nicky. May you provide me the simulink file? Thanks in advance
Nicky Man el 13 de Mayo de 2018
Here you are. Let me know if it works or not.
https://drive.google.com/file/d/1ld9JExjWdWl8oDiPtMAot4Wi5-hbVWAa/view?usp=sharing
Regards, Nick

Iniciar sesión para comentar.

### Respuestas (2)

Cosimo Mercuro el 26 de Abr. de 2018
Hi Nicky. I've the same issue. Have you found any solution? Thanks in advance
##### 1 comentarioMostrar -1 comentarios más antiguosOcultar -1 comentarios más antiguos
Nicky Man el 27 de Abr. de 2018
Hi Cosimo,
Yes. I added a delay block as an input u2 to the if statement block. I set the delay block to the amount of time I wish for the motor to be delayed. The delay block becomes u1 after this period of time. The logic in the if statement is that if u2 becomes u1, then it will output the constant 8, which stops the stepper motor.

Iniciar sesión para comentar.

Michael Goebel el 24 de Jun. de 2020
You could try to implement it with
• stateflow or
• an enabled subsystem or
• look under the mask of the repeating sequence block and adjust it as u want
##### 0 comentariosMostrar -2 comentarios más antiguosOcultar -2 comentarios más antiguos

Iniciar sesión para comentar.

### Comunidades de usuarios

Más respuestas en  Power Electronics Control

### Categorías

Más información sobre Electromechanical en Help Center y File Exchange.

### Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by