Problem when trying to use the Spectrum Analyzer in Simulink.
263 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Greetings ... I am new to the community as well as simulink. The problem I have is that I can not use the Spectrum Analyzer in Matlab R2015a, and whenever I try to open the block only a minimized white window appears, as shown in the attached image and where I can read.
- Spectrum can not be displayed for continuous or infinite sample times.*
Someone knows if I need to configure any parameter of the analyzer, since I can not observe anything when I connect a sinusoidal signal directly. I leave attached an image of the simulation in simulink.
0 comentarios
Respuestas (3)
Amir Salar
el 3 de Feb. de 2022
Editada: Amir Salar
el 3 de Feb. de 2022
I know it is a little late to answer you Cesar but I will write it anyway I hope it can help people in the future,
I tried to fix this issu by double clicking on my input signals then click on Signal Attributes and scroll down you will see "Sample time" write: 1/(whatever you sample frequency is) ;
Forexample I defined my sample frequency as Fs=96; (this part in matlab)
then I write 1/Fs (this part in simulink)
it solved my problem
0 comentarios
nada khatib
el 12 de Mayo de 2023
You have to use "signal specfication" block between the spectrum analyzer and the signal you want to see its spectrum. Then set the sample time inside the block "signal specification" to specific value (such as 1/320000)
0 comentarios
Starhowl
el 21 de En. de 2020
In my case it was because the sampling frequency of the window was set to 1, while that of all other blocks was set to 1/44100. It didn't matter that all blocks were set to discrete!
0 comentarios
Ver también
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!