Simulink (switch)
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
I built 2 differential equations in Simulink (see attachment). How can I combine both of them using the switch block?
If x>-0.1, the upper one has to be my output and if x<-0.1, the lower one has to be my output.
Thanks in advance
0 comentarios
Respuestas (1)
Jim Riggs
el 2 de Abr. de 2019
Editada: Jim Riggs
el 2 de Abr. de 2019
This problem may be complicated since you have 2 different definitions of x. However, based on what you asked for, this should work.
The upper signal is passed through whenever f1(x) is greater than -0.1. If f1(x) <= -0.1, the lower signal is passed through.
Note that the switch will always use the value of f1(x) to determine which value to pass.
0 comentarios
Ver también
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!