Simulink communication with a physical CAN device

2 visualizaciones (últimos 30 días)
Aljaz Zirkelbach
Aljaz Zirkelbach el 3 de Jul. de 2019
Respondida: Diego Kuratli el 12 de Jul. de 2019
  • Is it possible for simulink to communicate with a physical CAN device over Ethernet in real-time?
  • My setup would look like this: Simulink outputs data through ethernet port --(Ethernet cable)--> Ethernet/CAN gateway --(CAN cables)--> PCU device takes the data, calculates new values and send them back to Simulink model... the cycle repeats.
  • Let's assume I don't know the PCUs and gateways MAC addresses (if it matteres in any way).
  • I guess I would have to use the Real-Time Toolbox, which includes the Ethernet communication. Has anyone every tried to do a similar communication and can confirm that this should work?

Respuesta aceptada

Diego Kuratli
Diego Kuratli el 12 de Jul. de 2019
You can use Simulink Real-Time and Speedgoat real-time target machine with a CAN I/O module. You will generate a real-time application from your Simulink model, to run on the real-time target machine. You can connect to to your CAN devices without requiring an Ethernet/CAN gateway.
If the Ethernet gateway is a requirement, Simulink Real-Time includes driver blocks for UDP and TCP communication.

Más respuestas (0)

Productos


Versión

R2017a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by