How can I comment out an outport in Simulink model?
13 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Sebastian Inderst
el 30 de Jul. de 2019
Respondida: Marcelo Moraes
el 11 de En. de 2022
I have the case where a subsystem of my model can be commented out. In that case, the outports connected to the outputs of that subsystems will give a zero when the simulation is run. In my case, I don't want anything at all, since afterwards I'm checking if a given signal exists or not, and since a 0 was given, the signal seems to exist, but it should not.
If I simply use Ctrl+Shift+X (Comment Out) on the outport, I get the warning dialog "Commenting out of the following block(s) is not supported: my_model/my_outport".
Running on Matlab 2017b.
0 comentarios
Respuesta aceptada
Alex Burbee
el 30 de Jul. de 2019
In my exerience, you can deleate the out port or simply use a termination block where it comes out.
Hope it helps
0 comentarios
Más respuestas (1)
Marcelo Moraes
el 11 de En. de 2022
Indeed it is not supported, but it's very frustrating.
It's like trying to add a // in the begining of a C code line and being forced to delete it before compilation.
0 comentarios
Ver también
Categorías
Más información sobre Sources en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!