How to simulate and verify a dc motor performance on simscape
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Andrea Ongaro
el 9 de Ag. de 2019
Respondida: Steve Miller
el 4 de Ag. de 2020
Hi everyone,
i'm trying to verify if a dc motor+transmission system is suitable for an application and if the force that is actuated is enough.
To be precise enough what could be the suitable way to verify if the force is enough? the first problem is the simulation of the load, that is a load that increase up to 200 N in a space of 3 mm and reched this peak, goes down quite vertically.
Do you some advice for me? i'm quite a beginner with matlab and simscape, so i hope to get some advices.
Thanks in advance.
2 comentarios
Nikhil Sonavane
el 19 de Ag. de 2019
It would be better if you can give a detailed explaination of your problem statement. Also, if possible share your simulation model.
Respuesta aceptada
Steve Miller
el 4 de Ag. de 2020
I think all you need to add is a force sensor to see how much force your actuator is delivering.
I have attached an updated model, and you can see how to add the sensor in the screenshot below.
0 comentarios
Más respuestas (0)
Ver también
Categorías
Más información sobre Permanent Magnet en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!