How to make 1-D Look-Up Table block run repeatedly
4 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Viacheslav Solovievskyi
el 18 de Sept. de 2019
Respondida: Chaitanya Mallela
el 30 de Dic. de 2020
Hello everyone,
Now I'm looking for a way to interpretate a time related values as a signal into Simulink. The data is imported from .xml table and each value have a corresponding time value. My problem - that if i use Clock block - it would appear in the simulation only once. I tried to use reminder after devide, but in this case I can't change the time intervals between repeating the signal.
I'd like to know, how can I make 1-D Look-Up Table block run more then one time? My current solution would be attached.
The constant value - last time data for this set.
0 comentarios
Respuestas (1)
Chaitanya Mallela
el 30 de Dic. de 2020
You can use Counter block before 1-D Look-Up Table block with Reset port enabled. When count reaches maximum value Reset port is enabled which restarts the Counter.
0 comentarios
Ver también
Categorías
Más información sobre String en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!