problems connecting a Voltage Measurement Block to parallel RLC branch circuit.
6 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
RE: SimPowerSystems. When I try to connect a Voltage Measurement block to a "terminal" on the Parallel RLC branch block all I get is a dashed red line indicating no connection.
When I instead try to connect to the branch in the middle of the existing connection line, a "tie point" is created and the connection turns black. It appears to connect properly. Alas when I attempt to run the simulation it indicates that the voltage measurement block input is not connected.
0 comentarios
Respuestas (1)
Joel Van Sickel
el 11 de Dic. de 2020
I'm sorry this answer comes too late to be useful:
It sounds like the first issue is a UI bug preventing connection of lines that should work. As I can no longer check the images, I must assume that in the 2nd case, the voltage measurement was not connected correctly such as to give the correct output. That issue has certainly been fixed at this point.
0 comentarios
Ver también
Categorías
Más información sobre Variable Initialization en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!