Flash Simulink Model via CAN to F28379D

Hello,

I want to Flash my Simulink Model via CAN on the TI C2000 Launchpad F28379D.

With the Serial communication it works fine, but if I change the communication Interface t

o CAN it doesnt. I actually use a "Kvaser Leaf ight" USB to CAN adapter and the CAN B

Pins at J12.

Thanks for your help

Best regards

Michi

[Venkatesh Chilapur]

Hi Timo,

Do you want to run external mode over CAN? Here is the link to the same:

https://www.mathworks.com/help/releases/R2019b/supportpkg/texasinstrumentsc2000/examples/can-calibration-protocol-and-external-mode.html

Flash option over CAN is not supported and that serial flashing over USB via FTDI chip is the one which works for Flashing which I think is already working for you.

Regards,

Venkatesh C