How to use PS Lookup Table

24 views (last 30 days)
Is it possible to use Lookup table within the electrical Simscape, meaning voltage is inputted to the lookup table and that table outputs other voltage based on the input?
We are aware of PS Lookup Table, but we have not managed to successfully use it. The only way to use it, appears to be to use Voltage Sensor to plug V into x of PS Lookup Table. Then connect f of PS Lookup table to Controlled Voltage Source. But I am not sure if this is correct way.
There is also Simulink Lookup Table, but we were not able to plug it into electrical circuit.
Any advice if this is possible at all, and if it is what is the correct way to do it?

Accepted Answer

Prasanna Gude
Prasanna Gude on 3 Mar 2020
Yes, it is possible to use PS Lookup Table in an electrical circuit. Refer to the following link to know more about PS Lookup Table:
If you do want to connect Simulink Lookup Table to an electrical circuit, first connect the PS-Simulink Converter block to the electrical circuit and then connect Simulink Lookup Table block to it.

More Answers (0)

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by